resetting the configuration on a cisco 2950 switch

Resetting the configuration on a cisco 2950 switch serial#
Resetting the configuration on a cisco 2950 switch software#
Resetting the configuration on a cisco 2950 switch password#

When the login page appears, choose the language that you prefer to use in the web-based interface and enter the username and password.How do I configure an IP address on a Cisco 2960 switch? How do I log into a Cisco switch?Įnter the IP address of the switch that you are configuring in the address bar on the browser, and then press Enter. Most routers and switches by Cisco have default passwords of admin or cisco, and default IP addresses of 192.168. Verify connectivity using ping and Telnet.Verify the configuration of the switch.Configure the management interface on VLAN 1.Connect the router to the switch and configure the router.Connect the hosts to the switch and configure them.

Resetting the configuration on a cisco 2950 switch serial#

Step 3: Download Putty and Start a Serial Connection.

Step 2: Verify that it is a console cable.

Step 1: Connect the console cable to your PC.

How do I reset my Cisco router to factory settings without a password?

Initialize the flash file system with the command: flash_init.

Connect up your console cable and power on the switch, whilst holding down the “mode” button: ….

The switch has a default IP address “ 10.0. What is the default IP address of Cisco 2960? Press and hold the front panel MODE button, and power-up the switch. – Hitting return should give a prompt, confirming the connection. Connect the blue console cable, and open a TTY session: 9600,8,n,1.

Resetting the configuration on a cisco 2950 switch password#

Procedure to reset a Cisco 2960 (or 2950) password without losing the switch configuration. How do I change the password on my Cisco 2960?

Resetting the configuration on a cisco 2950 switch software#

Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control. Connect the other end of the cable to the console port on the switch.

Connect the supplied RJ-45-to DB-9 adapter cable to the 9-pin serial port on the PC.

… To further boot the switch run the boot command as: How do I access my Cisco 2960 switch? … To initialize the flash file system, run the command: … You can now list the contents of your flash by running. Power off the switch first, then press and hold the mode button while you power on the switch again. How do I reset my Cisco 2960 console password?

26 What is the standard default gateway?.

25 How do I find the IP address of my switch?.

23 How do you set the default gateway on a Cisco switch?.

22 What is default username and password for Router?.

21 How do I find the IP address of my Cisco switch?.

20 How do I find my Cisco WiFi password?.

19 How do I access a Cisco switch remotely?.

15 How do I reset my Cisco 2950 to factory settings?.

14 How do you set a Cisco switch to default?.

12 What is the username and password of Cisco?.

11 How do I reset my Cisco switch password?.

6 How do I reset my Cisco router to factory settings without a password?.

4 What is the default IP address of Cisco 2960?.

3 How do I change the password on my Cisco 2960?.

2 How do I access my Cisco 2960 switch?.

1 How do I reset my Cisco 2960 console password?.